Wilson Electronics LLC 460008 ユーザーズマニュアル

ENGLISH

2.   Run the outside antenna cable 

into the car. The cable is strong 

enough that it may be shut in most 

vehicle doors without damaging the 

cable. For a cleaner look, carefully 

pull down the door seal, run the 

cable under the seal, and push the 

seal back into place. This method 

reduces wear on the cable as the 

door opens and closes.

3.   Install the Low-Profile inside antenna.
 

•  Identify a place on the right side 

of the driver’s seat to mount the 

inside antenna. The location 

should be at least 18 inches from 

where the cellular device will be 

used.

 

 •  Install the inside antenna at the 

same angle as the cell phone 

when held in use or near the 

laptop’s cellular data card to 

maximize signal strength.

 

  For a more professional look, 

you can install the inside antenna 

underneath a car seat cover or 

upholstery.

 

•  When you have tested the 

functionality of your Drive 4G-M 

Signal Booster, mount the inside 

antenna by peeling off the backing 

of the Velcro

®

 and attach it to your 

selected location on the seat and 

secure the inside antenna.

4.   Place and connect the Drive 4G-M 

Signal Booster.

 

•  Select a location for the Signal 

Booster that is free from excessive 

heat, direct sunlight and moisture 

and that has proper ventilation. 

Good locations include underneath 

a seat or under the dashboard.

 

•  Connect the wire from the outside 

antenna to the port labeled 

“outside antenna” on the Signal 

Booster.

 

 

   

 

 

•  Connect the wire from the inside 

antenna to the port labeled “inside 

antenna” on the Signal Booster.

 

 

   

 

 

•  Plug the power adapter into 

vehicle’s 12V DC power supply 

and attach the cord to the side of 

Power Booster labeled “Power.” 

NOTE: Do NOT connect the power 

to the Signal Booster until you 

have connected both the inside 

and outside antennas.

 

•  Power up your Signal Booster by 

flipping the switch on the back of the 

DC power adapter on. A red light 

should appear on the power adapter.