Wellink Corporation NEOBIT1014VA ユーザーズマニュアル
NEOBIT 1014VA ADSL Router User’s Guide
Chapter3
Step 2. Connect the Ethernet cable.
If you are connecting a LAN to the NEOBIT 1014VA ADSL Router,
attach one end of a provided Ethernet cable to a regular hub port
and the other to the Ethernet port on the NEOBIT 1014VA.
attach one end of a provided Ethernet cable to a regular hub port
and the other to the Ethernet port on the NEOBIT 1014VA.
If you are using the NEOBIT 1014VA with a single computer and no
hub, you must use a “crossover” Ethernet cable (not provided) to
attach the PC directly to the device. The crossover cable is wired
differently than the cable you would use to connect to a hub. When
you compare the colored wires on each end of a straight-through
cable, they will be in the same sequence; on crossover cables, they
will not. Contact your ISP for assistance.
hub, you must use a “crossover” Ethernet cable (not provided) to
attach the PC directly to the device. The crossover cable is wired
differently than the cable you would use to connect to a hub. When
you compare the colored wires on each end of a straight-through
cable, they will be in the same sequence; on crossover cables, they
will not. Contact your ISP for assistance.
Step 3. Attach the power connector.
Connect the AC power adapter to the PWR connector on the back
of the device and plug in the adapter to a wall outlet or power strip.
of the device and plug in the adapter to a wall outlet or power strip.
Step 4. Turn on the NEOBIT 1014VA and power up your systems.
Press the Power switch on the back panel of the device to the ON
position.
position.
Turn on and boot up your computer(s) and any LAN devices such
as hubs or switches.
as hubs or switches.
Step 5: Install USB software and connect the USB cable.
You can attach a single computer to the device using a USB cable.
The USB port is useful if you have a USB-enabled PC that does not
have a network interface card for attaching to your Ethernet network.
The USB port is useful if you have a USB-enabled PC that does not
have a network interface card for attaching to your Ethernet network.
Before attaching the USB cable, you must install a USB driver and
configure the computer. For complete instructions, see page 24.
configure the computer. For complete instructions, see page 24.