Wellink Corporation NEOBIT1014VA ユーザーズマニュアル

Now that the USB driver installation is complete, you must configure 
the USB PC so that its IP properties place it on the same subnet as 
the NEOBIT 1014VA’s USB port. There are two ways to do this: 

 The NEOBIT 1014VA is configured to assign an 

appropriate IP address to the USB PC. If you want to use 
this automatic assignment feature, called “DHCP server,” 
you must configure the USB PC to accept dynamically 
assigned IP information. Follow the instruction on pages 18 
through 22 that correspond to the operating system 
installed on the PC. 

 If you want to assign a static IP address to the PC, follow 

the instructions on page 23 and use the following 
information. 

•

  In the Network and Dial-up Connections window, be 

sure to select the icon that corresponds to your new 
USB connection (not the one that corresponds to your 
Ethernet NIC). When you display the properties for the 
icon, the following text should display in the Connect 
Using text box: 

•

  The USB port on the NEOBIT 1014VA is preconfigured 

with these properties: 

USB port IP address:  

192.168.1.2 

USB port subnet mask: 255.255.255.0 

Therefore, your PC must be configured as follows: 

IP address: 

192.168.1.n where n is a 
number from 2 to 254. 

255.255.255.0