Comba Telecom Ltd. RX4122-B ユーザーズマニュアル
INSTALLATION GUIDE FOR RX-4122
ENU STATUS : 1-0-1
Copyright - refer to title page
Page 29
Figure 15: 400MHz Screen
5.2.2 [COMMISSIONING]
A work flow of the commissioning process is shown on [Commissioning] Screen. Click the [Start] button, the
software will guide you through the commissioning step by step. For details, please refer to chapter 5.3.
software will guide you through the commissioning step by step. For details, please refer to chapter 5.3.
Figure 16: [Commissioning] Screen
5.2.3 [FIRMWARE]
There are two functions on the [Firmware] bar: [upgrade] and [swap]. [Upgrade] is used to upgrade software,
and [Swap] is to replace the current firmware version with the previous one.
Follow the steps shown below figure to upgrade the firmware.
and [Swap] is to replace the current firmware version with the previous one.
Follow the steps shown below figure to upgrade the firmware.
Click to set Freq Low and
High, DL/UL Gain,
Enable/disable RF switch.
High, DL/UL Gain,
Enable/disable RF switch.
DL Freq Low
and High of
sub-bands
and High of
sub-bands
RF parameters
of sub-bands
of sub-bands
Sub-bands
switch status
switch status