Netgear 06100027 ユーザーズマニュアル

2-2

Introduction

The WG302 Wireless Access Point is easy-to-use and provides solid wireless and networking 
support.

The following standards and conventions are supported:

•

Standards Compliant. The Wireless Access Point complies with IEEE 802.11g standards for 
Wireless LANs.

•

WEP support. Support for WEP is included. 64-bit, 128-bit, and 152-bit keys are supported.

•

Full WPA and WPA2 support. WPA and WPA2 enterprise class strong security with 
RADIUS and certificate authentication as well as dynamic encryption key generation. 
WPA-PSK and WPA2-PSK pre-shared key authentication without the overhead of RADIUS 
servers but with all of the strong security of WPA.

•

Multiple BSSIDs. Support for multiple BSSIDs. When one AP is connected to a wired 
network and a set of wireless stations it is referred to as a Basic Service Set (BSS). The Basic 
Service Set Identifier (BSSID) is a 32-character unique identifier attached to the header of 
packets sent over a WLAN that differentiated one WLAN from another when a mobile device 
tries to connect to the network.

•

DHCP Client and Server Support. DHCP provides a dynamic IP address to PCs and other 
devices upon request. The WG302 can obtain network information from a DHCP server on 
your network. The AP can also act as a DHCP server and provide network information for 
wireless clients.

•

SNMP Support. Support for Simple Network Management Protocol (SNMP) Management 
Information Base (MIB) management.

The WG302 provides solid functionality, including these features:

•

Multiple Operating Modes 

–

Wireless Access Point. Operates as a standard 802.11g.

–

Point-to-Point Bridge. In this mode, the WG302 only communicates with another 
bridge-mode wireless station. You must enter the MAC address (physical address) of the 
other bridge-mode wireless station in the field provided. You should use wireless security 
to protect this communication.