Netgear 06100027 ユーザーズマニュアル
Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302
Advanced Configuration
5-11
v0.1, December 2005
Multi-Point Bridge Configuration
Set up a Multi-Point Bridge only if this WG102 is the “master” for a group of bridge-mode
wireless stations. Then all traffic is sent to this “master,” rather than to the other access points. In
addition, you can enable client associations with this WG302.
wireless stations. Then all traffic is sent to this “master,” rather than to the other access points. In
addition, you can enable client associations with this WG302.
•
You must enter the MAC addresses of the other access points in the fields provided.
•
The other bridge-mode wireless stations must be set to Point-to-Point Bridge mode, using the
MAC address of this WG102 as the Remote MAC Address.
MAC address of this WG102 as the Remote MAC Address.
•
Use WEP to protect this traffic.
The figure below shows an example of a Multi-Point Bridge mode configuration.
Follow the steps below to set up the Multi-Point Bridge configuration.
1. Configure the Operating Mode of the WG302 Wireless Access Points.
•
Because it is in the central location, configure WG302 (AP 1) on LAN Segment 1 in
Point-to-Multi-Point Bridge mode. The MAC addresses of AP2 and AP3 are required in
AP1.
Point-to-Multi-Point Bridge mode. The MAC addresses of AP2 and AP3 are required in
AP1.
•
Configure WG302 (AP 2) on LAN Segment 2 in Point-to-Point Bridge mode with the
Remote MAC Address of AP1.
Remote MAC Address of AP1.
Figure 5-8
AP 1
AP 2
Router
Internet
Hub or Switch
192.168.0.1
PCs
PCs
AP 3
“Master AP”
PCs
LAN Segment 1
LAN Segment 2
LAN Segment 3
Hub or Switch
Point-to-Multi-Point
Bridge mode
Bridge mode
Point-to-Point
Bridge Mode
Bridge Mode
Point-to-Point
Bridge Mode
Bridge Mode