Netgear 06100042 ユーザーズマニュアル

TM

Advanced Configuration

5-9

9. If your dynamic DNS provider allows the use of wildcards in resolving your URL, you can 

select the Use wildcards check box to activate this feature. For example, the wildcard feature 
will cause *.yourhost.dyndns.org to be aliased to the same IP address as yourhost.dyndns.org

10. Click Apply to save your configuration. 

Static Routes provide additional routing information to your router. Under normal circumstances, 
the router has adequate routing information after it has been configured for Internet access, and 
you do not need to configure additional static routes. You must configure static routes only for 
unusual cases such as multiple routers or multiple IP subnets located on your network.

As an example of when a static route is needed, consider the following case:

•

Your primary Internet access is through a cable modem to an ISP.

•

You have an ISDN router on your home network for connecting to the company where 
you are employed. This router’s address on your LAN is 192.168.0.100.

•

Your company’s network is 134.177.0.0.

When you first configured your router, two implicit static routes were created. A default route was 
created with your ISP as the wireless modem router, and a second static route was created to your 
local network for all 192.168.0.x addresses. With this configuration, if you attempt to access a 
device on the 134.177.0.0 network, your router will forward your request to the ISP. The ISP 
forwards your request to the company where you are employed, and the request will likely be 
denied by the company’s firewall.

In this case you must define a static route, telling your router that 134.177.0.0 should be accessed 
through the ISDN router at 192.168.0.100. The static route setup would look like 

Note: If your ISP assigns a private WAN IP address such as 192.168.x.x or 10.x.x.x, the 

dynamic DNS service will not work because private addresses will not be routed 
on the Internet