Netgear 06200047 ユーザーズマニュアル

8-6

You can ping the router from your computer to verify that the LAN path to your router is set up 
correctly.

To ping the router from a PC running Windows 95 or later:

1. From the Windows toolbar, click the Start button and select Run.

2. In the field provided, type Ping followed by the IP address of the router, as in this example:

3. Click OK.

You should see a message like this one:

If the path is working, you see this message:

If the path is not working, you see this message:

If the path is not functioning correctly, you could have one of the following problems:

•

Wrong physical connections

–

Make sure the LAN port LED is on. If the LED is off, follow the instructions in 

–

Check that the corresponding Link LEDs are on for your network interface card and 
for the hub ports (if any) that are connected to your workstation and router.

•

Wrong network configuration

–

Verify that the Ethernet card driver software and TCP/IP software are both installed 
and configured on your PC or workstation.

–

Verify that the IP address for your router and your workstation are correct and that the 
addresses are on the same subnet.

After verifying that the LAN path works correctly, test the path from your PC to a remote device. 
From the Windows run menu, type: