Netgear 10400144 ユーザーズマニュアル

Installing Your Wireless Router Manually (Advanced and Linux Users)

15

•

LAN. At least one LAN light (4) should be lit. Green indicates that your computer is 
communicating at 1 Gbps; amber indicates 10/100 Mbps. If a LAN light is not lit, check that 
the Ethernet cable from the computer to the router is securely attached at both ends, and that 
the computer is turned on.

•

USB. The USB light (5) should be lit if a USB device is connected and ready to be used. The 
light will be fast blinking green when the USB device is in use.

•

WLAN On/Off. The Wireless Local Area Network (WLAN) button (6) turns the 2.4 GHz and 
5.0 GHz wireless radios on and off.

•

WPS. The WPS button (7) shows blinking green to indicate WPS activity, when the device is 
in the 2 minute interval to synchronize security or there is a WPS error.

When configuring your wireless router manually, you must log in to your N750 wireless gigabit 
router to set it up initially and to make any changes to your wireless router’s settings later.

Connect to the N750 wireless gigabit router by typing http://www.routerlogin.net in the 
address field of your browser, and then press Enter.

The factory default state is reset when you use the Restore Factory Settings button. 
See 

 for 

more information.

Connect to the N750 wireless gigabit router by typing any one of these three URLs 
in the address field of your browser, then pressing Enter: