Netgear WG102 ユーザーズマニュアル

5-6

Advanced Configuration

•

All WG102 Access Points use the same SSID, Channel, authentication mode, if any, and 
encryption in use.

•

All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address 
field.

3.

Verify connectivity across the LANs. 

•

A computer on any LAN segment should be able to connect to the Internet or share files 
and printers with any other PCs or servers connected to any of the three LAN segments.

•

Wireless stations will not be able to connect to the WG102 Access Points in the 
illustration above. If you require wireless stations to access any lan segment, you can 
additional WG102 Access Points configured in Wireless Access Point mode to any LAN 
segment.

Note: You can extend this multi-point bridging by adding additional WG102s configured in 
Point-to-Point mode for each additional LAN segment. Furthermore, you can extend the range of 
the wireless network with NETGEAR wireless antenna accessories.

1.

Configure the Operating Mode of the WG102 Access Points.

–

WG102 (AP1) on LAN Segment 1 in Repeater mode with the Remote MAC Address of 
AP2.

–

Configure WG102 (AP2) in Repeater mode with MAC addresses of AP1 and AP3.

+ˉ™Ë-j¬j?ÍjÁË aj
݉͆ËW‰j™ÍË?ÄĝW‰?͉™Ä

!Ë
.j~”j™Íˤ

+ˉ™Ë-j¬j?ÍjÁË aj
݉͆ËW‰j™ÍË?ÄĝW‰?͉™Ä

+ˉ™ËËËËË-j¬j?ÍjÁË aj
݉͆ËËËËW‰j™ÍË?ÄĝW‰?͉™Ä

8‰ÁjjÄÄË+
ÄĝW‰?ÍjaË݉͆Ë+Ï

8‰ÁjjÄÄË+
ÄĝW‰?ÍjaË݉͆Ë+Ô

8‰ÁjjÄÄË+
ÄĝW‰?ÍjaË݉͆Ë+¤