Netgear wgr101 ユーザーズマニュアル

This is to certify that the 54 Mbps Wireless Travel Router WGR101  is shielded against the generation of radio 

interference in accordance with the application of Council Directive 89/336/EEC, Article 4a. Conformity is declared by 

the application of EN 55 022 Class B (CISPR 22).
Compliance with the applicable regulations is dependent upon the use of shielded cables. It is the responsibility of the 

user to procure the appropriate cables. 

This device is intended to be operated in all countries of the European Community.  Requirements for indoor vs. outdoor 

operation, license requirements and allowed channels of operation apply in some countries as described below.
NOTE: The user must use the configuration utility provided with this product to ensure the channels of operation are in 

conformance with the spectrum usage rules for European Community countries as described below. 

•

This device requires that the user or installer properly enter the current country of operation in the Radio 

Configuration Window as described in the user guide, before operating this device.

•

This device will automatically limit the allowable channels of operation applicable to each country.  Incorrectly 

entering the country of operation may result in illegal operation and may cause harmful interference to other 

system.  The user is obligated to ensure the device is operating according to the channel limitations, indoor/outdoor 

restrictions and license requirements for each European Community country as described in this document.

•

This device may be operated indoors or outdoors in all countries of the European Community using the 2.4GHz 

band except where noted below. 

•

In Italy the end-user must apply for a license from the national spectrum authority to operate this device outdoors. 

•

In France outdoor operation is only permitted using the 2.4 – 2.454 GHz band: Channels 1 – 7.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to  

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following measures:
•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help. 

1. FCC RF Radiation Exposure Statement: The equipment complies with FCC RF radiation exposure limits set forth 

for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 

centimeters between the radiator and your body. 

2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 3. 

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the 

user authority to operate the equipment.

 

To assure continued compliance, any changes or modifications not expressly approved by the 

party responsible for compliance could void the user's authority to operate this equipment. 

(Example - use only shielded interface cables when connecting to computer or peripheral 

devices).