Intellinet 560436 ユーザーズマニュアル

 

  

Reduce costs by using existing Cat5 cable to provide both power and data.

The INTELLINET NETWORK SOLUTIONS Power over Ethernet PoE+ Injector allows you to
connect your IEEE 802.3af/at-compliant products to a non-PoE LAN switch port. The injector can
be used to connect a wireless access point, IP phone, network camera or any IEEE
802.3af-powered device (PD) to a switch. The device has an output power rating of up to 30 Watts.
That's enough for even power-hungry PoE devices.

No need to run AC power lines for your wireless access point, network camera or IP phone. Simply connect the PoE Injector to the LAN
switch port, and use the existing Cat5 cabling to deliver DC power as well as transfer data.

Does your existing LAN switch not support the new IEEE 802.3af PoE standard? Well, don’t let that stop you from realizing the benefits
of delivering DC power over the existing Cat5 Ethernet cabling. Use the Model 560436 PoE Injector until you are able to upgrade your
LAN switch to a model that supports the IEEE 802.3af PoE standard.

Now that you are running DC power to your networked equipment through the Cat5 cabling, you need to be sure that the products are
protected from power problems. The PoE Injector was designed to protect equipment from short circuits (short GRND), current overloads

(over 450 mA) and high voltages (voltage exceeding 52 V).

Features:

Ideal when AC power is not available
IEEE 802.3at compliant (PoE+)
Power output of up to 30 Watts
Supports all IEEE 802.3at- and IEEE 802.3af-compliant PoE devices (Wireless LAN access points and
bridges, VoIP (Voice over Internet Protocol) telephones, IP surveillance cameras)
Supports IEEE 802.3at/af detection and short circuit, overload and high-voltage protection
Compact metal case
Three-Year Warranty