AeroScout ANT4200 ユーザーズマニュアル
AeroScout EX4200 Ultrasound Exciter
Connecting the Exciter to the Network and Power Source
11
Usage option
Description
Single Exciter with External
LF Antenna unit
LF Antenna unit
There is an option to connect an External LF
Antenna unit to the EX4200 Exciter. The
External LF Antenna unit should be mounted
outside the room, next to the door. It should be
configured to turn off the ultrasound receiver
of the T2u Tag.
Antenna unit to the EX4200 Exciter. The
External LF Antenna unit should be mounted
outside the room, next to the door. It should be
configured to turn off the ultrasound receiver
of the T2u Tag.
Power Supply Options
The various power supply options for powering up the Exciter are described below.
Direct Power Supply
Directly connect a 48VDC power source to the Exciter’s power jack (connector 2 in
Figure 2).
Directly connect a 48VDC power source to the Exciter’s power jack (connector 2 in
Figure 2).
Note
An Exciter requires approximately 10W of power. When connecting an Exciter
to a direct power source with one of the above voltage levels, verify that the
current level is sufficient.
to a direct power source with one of the above voltage levels, verify that the
current level is sufficient.
When using a direct power source for chained Exciters, you can drive power
to no more than three Exciters sequentially even if the source power is
sufficient for more.
to no more than three Exciters sequentially even if the source power is
sufficient for more.
Unit shall be powered only by limited power source (marked LPS or NEC
class 2) power supply.
class 2) power supply.
PoE Switch
If your network has a Power-over-Ethernet infrastructure, you can connect a CAT-5
Ethernet cable from the PoE switch to the Exciter’s LAN connector (connector 1 in
Figure 2). This supplies both the power and the network connection.
If your network has a Power-over-Ethernet infrastructure, you can connect a CAT-5
Ethernet cable from the PoE switch to the Exciter’s LAN connector (connector 1 in
Figure 2). This supplies both the power and the network connection.
Note
PoE standard 802.3af class 0 allows power for not more than one Exciter.
When using PoE with chained Exciters, a PoE connection must be made to
every single Exciter in the chain. In addition, the LAN connectivity that the
PoE supplies will not be utilized for slave Exciters in a chain.
When using PoE with chained Exciters, a PoE connection must be made to
every single Exciter in the chain. In addition, the LAN connectivity that the
PoE supplies will not be utilized for slave Exciters in a chain.