AeroScout BS2035-1 ユーザーズマニュアル

Installing the Exciter 

This section explains how to install an Exciter unit. 

Preparing the Cables and Connectors 

Network: 

Connect the LAN cable to the LAN connection on the 

Exciter.  

Power: 

Connect the power cable to the power jack. 

Configuring the Exciter 

Exciters are configured using the AeroScout System Manager. The 
configuration settings consist of device installation and network definitions. 

The configuration procedure involves the following steps: 

1.  Connect all Exciters with a wired Ethernet connection to a dedicated 

segment. 

2.  Add the Exciters to the system and define their IP settings (IP, subnet, 

gateway, ports) in the System Manager. 

3.  Verify that the Exciters’ status is OK. 

4.  Position the Exciter in the site according to site survey recommendations, 

and mount it. 

5.  Align the Exciters’ positions according to the required area coverage. 

      6.     Configure the Exciter’s settings.  

7.  If you wish to define the Exciter as an offline Exciter that is not 

connected to the network, you should approve the above configuration, 
wait for a confirmation, define the Exciter as disconnected from network, 

approve the settings again and disconnect the Exciter from the network.