ViVOtech Inc. VIVOPAYKIOSKII ユーザーズマニュアル
ViVOpay Kiosk II User Guide
631-0071-01 ViVOtech
Proprietary
Page 8 of 23
2.2 ViVOpay Kiosk II Installation
This section provides information on how to install the ViVOpay Kiosk II unit on a Kiosk.
2.3 Mounting the ViVOpay Kiosk II External Antenna
Use the following instruction for mounting the external antenna on the exterior of the Kiosk:
Note: Verify the orientation of the ViVOpay Kiosk II Antenna before marking and drilling the holes.
The 2 larger holes should be located towards the top of the mounting location to ensure that the
ViVOpay Kiosk II antenna is oriented correctly so that the LED lights are at the top.
The 2 larger holes should be located towards the top of the mounting location to ensure that the
ViVOpay Kiosk II antenna is oriented correctly so that the LED lights are at the top.
1. Using the Drill Template for the External Antenna (630-1056-00), locate and mark the four
4.4mm (0.173 inch) mounting holes.
2. Using the Drill Template for the External Antenna (630-1056-00 ), locate and mark the two
15.880 mm (0.625 inch) access holes (used for connecting the antenna power and the
LED power and data cable to the ViVOpay Kiosk II unit).
LED power and data cable to the ViVOpay Kiosk II unit).
3. Drill the four 4.4 mm (0.173) mounting holes using a number 17 drill bit.
4. Drill the two 15.88 mm (0.625 inch) holes using a 5/8 drill bit.
5. Remove the nuts from the four mounting screws.
6. Route the end of the cable (220-2457-00) with the RJ45 connector through the left 15.88
mm (0.625 inch) hole in to the Kiosk. Make sure that the front of the external antenna will be
properly oriented (not up side down) on the Kiosk before inserting the four screws into the
mounting holes.
properly oriented (not up side down) on the Kiosk before inserting the four screws into the
mounting holes.