Kirisun Communications Co. Ltd. PT820002 ユーザーズマニュアル
MANDATORY SAFETY INSTRUCTIONSTO INSTALLERS AND USERS
z Use Only manufacturer or dealer supplied antennas.
z Antenna minimum safe distance: 108 cm.
z Antennas used for this transmitter must not exceed an antenna gain of 3 dBi.
z Use Only manufacturer or dealer supplied antennas.
z Antenna minimum safe distance: 108 cm.
z Antennas used for this transmitter must not exceed an antenna gain of 3 dBi.
The FCC (Federal Communications Commission) has adopted a safety standard for human
exposure to RF energy which is below the OSHA (Occupational Safety and Health Act)
limits.
z Antenna mounting: The antenna supplied by the manufacturer or radio dealer must not be
z Antenna mounting: The antenna supplied by the manufacturer or radio dealer must not be
mounted at a location such that during radio transmission, any person can come closer than
the above indicated minimum safe distance to the antenna (i.e. 108cm).
z To comply with current FCC RF Exposure limitations, the antenna must be installed at or
exceeding the minimum safe distance indicated above, and in accordance with the
requirements to the antenna manufacturer or supplier.
z Vehicle installation: The antenna can be mounted at the center of a vehicle metal roof or
trunk lid if the minimum safe distance is observed.
Antenna substitution: Don’t substitute any antenna for the one supplied or recommended by
the manufacturer or radio dealer. You may be exposing person(s) to excessive radio frequency
radiation. You may contact your radio dealer or the manufacturer for further instructions.
Warning
Maintain a separation distance from the antenna to person(s) at least 108cm.
“This transmitter is authorized to operate with a maximum duty factor of 50%, in a typical
push-to-talk mode, for satisfying FCC RF exposure compliance requirements.”
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.