Norsat International Inc. NSLK3200 ユーザーズマニュアル

           099-20003-01OM 

Norsat

Page 73

2.

Disconnect the LNB cable from the connector on the Interface/Indicator
unit.

3.

Release the nylon clips fastenings located on the Boom Arm and Feed
Assembly.

4.

Turn the knobs counter-clockwise to disconnect the waveguide from the
OMT and waveguide flange.

5.

Place the waveguide in the allocated slot in the Accessories case.

6.

To disconnect the Feed Assembly from the Boom Arm, unfasten the collar
by turning it counter-clockwise.

7.

Remove the Feed Assembly from the Boom Arm. 

8.

Place the the Feed Assembly in the allocated slot in the Accessories
case.

9.

To disconnect the Boom Arm from the antenna base, unfasten the collar
by turning it counter-clockwise.

10. Remove the Boom Arm from the antenna base. 

11. Place the Boom Arm in the allocated slot in the Accessories case.

12. For the section 2 reflector panels, unfasten the camlocks by turning them

counter-clockwise.

13. Remove the section 2 reflector panels.

14. Disassemble the section 2 reflector panels by turning the camlocks

counter-clockwise.

15. Remove the section 1 reflector panel by turning the camlocks counter-

clockwise.

16. Remove the first nut securing the elevation rod and then remove the ele-

vation rod from the dish elevation axle hole.

17. Remove the second nut and the first knob.

18. Remove the elevation rod from the support base.

19. Thread the knobs and nuts back onto the elevation rod for storage.

20. Place the elevation rod in the allocated slot in the Accessories case.

21. Locate the Reflector Dish Pouch and the panel foam pieces.

22. Packing the reflector panels: refer to Figure 60 on page 74.

i.

Place the first reflector panel on the 3/16” foam sheet, and cover with
another piece of 3/16” foam. 

ii.

Repeat step ii for the second and third reflector panels, with the pan-
els rotated 180 degrees to that of the first panels.