Chung Nam Electronics Co. Ltd. WLANTPBG ユーザーズマニュアル

 

 

This equipment has been tested and found to comply with the limits for a class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. 

This equipment generates uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user 

is encouraged to try to correct the interference by one or more of the following measures: 

¾ 

Reorient or relocate the receiving antenna. 

¾ 

Increase the separation between the equipment and receiver. 

¾ 

Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

¾ 

Consult the dealer or an experienced radio/TV technician for help. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions:   

(1) 

This device may not cause harmful interference.

 

(2) This device must accept any interference received, including interference that may 

cause undesired operation

.

 

Changes or modifications to this unit not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment. 

 

   

This device is intended only form OEM integrators under the following conditions: 

1)  The antenna must be installed such that 20cm is maintained between the antenna and 

users, and 

2)  The transmitter module may not be co-located with any other transmitter or antenna. 

   

IMPORTANT NOTE: In the event that these conditions can not be met (for example 

certain laptop configurations or co-location with another transmitter), then the FCC 

authorization is no longer considered valid and the FCC ID can not be used on the final 

product. In these circumstances, the OEM integrator will be responsible for re-evaluating 

the end product (including the transmitter) and obtaining a separate FCC authorization. 

 

This transmitter module is authorized only for use in devices where the antenna may be 

installed such that 20 cm may be maintained between the antenna and users (for example 

access points, routers, wireless ADSL modems, and similar equipment). The final end 

product must be labeled in visible area with the following: 

“Contains TX FCC ID: Q72WLANTPBG”