Chung Nam Electronics Co. Ltd. WLC322NA ユーザーズマニュアル
OEM Manual
- 19 -
Chapter 4: Regulatory information
4.1 FCC Information to User
This product does not contain any user serviceable components. Any product changes
or modifications will invalidate all applicable regulatory certifications and approvals.
or modifications will invalidate all applicable regulatory certifications and approvals.
4.2 FCC Guidelines for Human Exposure
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or Transmitter.
between the radiator & your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or Transmitter.
4.3 OEM Integrator Notice
This device is intended only for OEM integrators under the following conditions:
(1) The antenna must be installed such that 20 cm is maintained between the antenna
(1) The antenna must be installed such that 20 cm is maintained between the antenna
and users;
(2) The transmitter module may not be co-located with any other transmitter or
antenna;
(3) For all products market in US, OEM has to limit the operation channels in CH1 to
CH11 for 2.4G band. OEM shall not supply any tool or info to the end-user
regarding to Regulatory Domain change. As long as 3 conditions above are met,
further transmitter test will not be required. However, the OEM integrator is still
responsible for testing their end-product (host of this device) for any additional
compliance requirements required.
regarding to Regulatory Domain change. As long as 3 conditions above are met,
further transmitter test will not be required. However, the OEM integrator is still
responsible for testing their end-product (host of this device) for any additional
compliance requirements required.
IMPORTANT NOTE: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the integrated
antenna may be installed such that 20 cm may be maintained between the antenna and
users. The final end product must be labeled in a visible area with the following:
“Contains FCC ID: Q72WLC322NA”.