Omni Key Technology Corp. KAROZRF-001 ユーザーズマニュアル
4
4. Hardware Installation
4.1 Sensor Setup step by step
Wireless: 1. Wireless Reed Sensor:
(1) Insert the DC 12V battery.
(2) When use the Wireless Reed Sensor, please push the switch to “ON”, it
(2) When use the Wireless Reed Sensor, please push the switch to “ON”, it
enters the standby.
(3) If the magnetic iron is far away it, the LED changes the red color and
transmits the message to the main machine. After two seconds, the power is
off and it enters save power mode.
off and it enters save power mode.
(4) If the electric power of battery is low, the LED will show (red+green) color.
Please change the battery.
(5) If user want to change the set of sensor, please open the case and change the
switch as below. It will cause the fail operation of system while wrong
setting.
setting.
Set
Switch
1 2 3 4 5 6 7 8
1
Off
Off
On
Off
On
Off
On
Off
2 On
On
Off
Off
On On Off
Off
3
On On On On Off
Off
Off
Off
4
Off
On On On On On On On
Caution: If use for long time and not turn OFF the sensor, please replace battery every
three mouth.
4.2 Main Machine Setup
1.
Connect DC 12V Transformer on Auto Alarm Power Jack.
2.
Press Reset Button, restart system.
3.
Proceed to System Setup. (Refer to system setup)
※When set up the Auto Alarm, let it be more than 70 cm far away ground. It must be far
away electric product and conductor in order to disturb and reduce received sensitivity.