Linksys EA6700 ユーザーズマニュアル

1

Wireless Regulatory Information

FCC Statement

This device complies with Part 15 of the FCC Rules . 

Operation is subject to the following two conditions: (1) 

This device may not cause harmful interference, and 

(2) this device must accept any interference received, 

including interference that may cause undesired 

operation .
This product has been tested and complies with the 

specifications for a Class B digital device, pursuant to 

Part 15 of the FCC Rules . These limits are designed 

to provide reasonable protection against harmful 

interference in a residential installation . This equipment 

generates, uses, and can radiate radio frequency 

energy and, if not installed and used according to the 

instructions, may cause harmful interference to radio 

communications . However, there is no guarantee that 

interference will not occur in a particular installation . If 

this equipment does cause harmful interference to radio 

or television reception, which is found by turning the 

equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following 

measures:

 • Reorient or relocate the receiving antenna
 • Increase the separation between the equipment or 

devices

 • Connect the equipment to an outlet other than the 

receiver’s

 • Consult a dealer or an experienced radio/TV technician 

for assistance

FCC Caution: Any changes or modifications not 

expressly approved by the party responsible for 

compliance could void the user’s authority to operate 

this equipment .
IEEE 802 .11b or 802 .11g operation of this product in 

the USA is firmware-limited to channels 1 through 11 .
The device for the band 5150-5250 MHz is only 

for indoor usage to reduce the potential for harmful 

interference to co-channel mobile satellite systems .

Mexico Regulatory Statement

La  operación de este equipo está sujeta a las 

siguientes dos condiciones: (1) es  posible que este 

equipo o dispositivo no cause interferencia perjudicial 

y (2)  este equipo o dispositivo debe aceptar cualquier 

interferencia, incluyendo la  que pueda causar su 

operación no deseada .

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure 

limits set forth for an uncontrolled environment . This 

equipment should be installed and operated with 

minimum distance 23 cm between the radiator and your 

body .
This device and it’s antennas(s) must not be co-located 

or operating in conjunction with any other antenna 

or transmitter except in accordance with FCC multi-

transmitter product procedures . 

Safety Notices

 

  Do not use this product near 

water, for example, in a wet basement or near 

a swimming pool .

 

 Avoid using this product during an 

electrical storm . There may be a remote risk of 

electric shock from lightning .

 

  This product may contain 

chemicals, known to the State of California 

to cause cancer, and birth defects or other 

reproductive harm . Wash hands after handling .

Industry Canada Statement

CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions:
1 .  This device may not cause interference and
2 .  This device must accept any interference, including 

interference that may cause undesired operation of 

the device .  

For product available in the USA/Canada market, only 

channel 1~11 can be operated . Selection of other 

channels is not possible .
The device could automatically discontinue transmission 

in case of absence of information to transmit, or 

operational failure . Note that this is not intended to 

prohibit transmission of control or signaling information 

or the use of repetitive codes where required by the 

technology .

Industry Canada Radiation Exposure 

Statement

This equipment complies with IC radiation exposure 

limits set forth for an uncontrolled environment . This 

equipment should be installed and operated with 

minimum distance 23 cm between the radiator & your 

body .
Cet appareil et son (ses) antenne (s) ne doivent pas être 

situés à proximité ou fonctionner en association avec 

une autre antenne ou un autre émetteur autre qu’en 

respectant les procédures d’ Industrie Canada relatives 

au fonctionnement des dispositifs multi-émetteurs .