Cardo Systems ER01 ユーザーズマニュアル
scala-rider manual
DRAFT APRIL 25, 2005
Page 9 of 31
4.1 Charging
Batteries
Make sure the headset is fully charged prior to initial use. Allow at
least six hours for a full charge before using for the first time.
Normally 5-6 hours will suffice for complete charge. The headset
should be off the helmet when being charged (solely for purposes of
convenience)
least six hours for a full charge before using for the first time.
Normally 5-6 hours will suffice for complete charge. The headset
should be off the helmet when being charged (solely for purposes of
convenience)
• Plug the Wall Charger into the charging socket of the headset and
connect it to an electrical outlet.
• The Red Light Indicator (LED) on the scala-rider will turn on when
charging begins. Allow the headset to charge until the Red LED turns
off.
off.
• When charging is complete, release the headset from the charger.
NOTE: You may leave the unit connected even if charging is completed.
There is no danger of over-charging.
NOTE: You may leave the unit connected even if charging is completed.
There is no danger of over-charging.
4.2
Attaching and removing the scala-rider from your helmet
4.2.1 First installation
Once the headset is fully charged you should proceed to pair it to
your mobile phone (see section 5 below). When done, you can
proceed with attaching the unit to your helmet.
your mobile phone (see section 5 below). When done, you can
proceed with attaching the unit to your helmet.
• The clamp serves as the base-cradle for the headset and must
be attached to your helmet before using the headset
• Use the enclosed Allen wrench to loosen the two screws of the
clamp (FIG. 1). Then slide the back-plate of the clamp between
the internal padding and the external shell of the helmet (FIG.
2).
the internal padding and the external shell of the helmet (FIG.
2).
• Before fastening the screws, make sure to adjust the clamp’s
location to an ideal position, i.e. to the spot where the attached
speaker and microphone are respectively opposite your ear and
just slightly off the corner of your mouth (FIG. 3). You may need
to re-position the clamp repeatedly until you identify the ideal
spot. The speaker can be easily placed into position and
removed by means of the Velcro layer that attaches to the inner
padding of your helmet.
speaker and microphone are respectively opposite your ear and
just slightly off the corner of your mouth (FIG. 3). You may need
to re-position the clamp repeatedly until you identify the ideal
spot. The speaker can be easily placed into position and
removed by means of the Velcro layer that attaches to the inner
padding of your helmet.
• Once you have identified the ideal position for the clamp, use
the Allen wrench to fasten the clamp.
• Now slide the scala-rider headset downward along the reel of
the clamp (FIG. 4) until a light clicking sound indicates that the
headset has reached its proper operational position.
headset has reached its proper operational position.