Promethean 006 ユーザーズマニュアル
ACTIVote User Guide
7
Channel – This allows you to set ACTIVote devices to use one of three unique
channels.
Board ID – This allows you to set the ACTIV board to be defined with one of 99
unique ID numbers.
unique ID numbers.
Therefore with systems in close proximity, you should set the channel and
Board ID to different values in each room. Continuing with our example, you
Board ID to different values in each room. Continuing with our example, you
could set the following values:
Room 1 : Channel = 1 and Board ID = 1
Room 2 : Channel = 2 and Board ID = 2
Whilst potential interference problems are negligible when systems are over 20
meters apart, it is good practice to always set different board IDs and channel
numbers for ACTIVote systems within the same building.
numbers for ACTIVote systems within the same building.
Registering Devices
Once you have chosen the appropriate channel and board ID, perform the
following:
following:
Click on the Register button.
The registration button of the ACTIVote image will flash with a yellow border to
indicate that the program is now waiting for you to register the first device.
The top row of the list will highlight in red, this indicates that the ACTIV board
The top row of the list will highlight in red, this indicates that the ACTIV board
is in registration mode and is searching for signals from any ACTIVote device.
Take the first ACTIVote device and depress the Registration button, hold it
down until you see the red LED flash briefly followed by a longer intermittent
down until you see the red LED flash briefly followed by a longer intermittent
flash from the green LED. You will see the ACTIVote device has been registered
and allocated a device name. The red highlight has moved down a line, waiting
and allocated a device name. The red highlight has moved down a line, waiting
for the next device to be registered.
Repeat the above procedure for each device you wish to register.
Once you have successfully registered all devices click on the Stop button.
Naming your ACTIVote devices
Each device is automatically given a Device
Name (A1, A2, A3 etc). It is possible to assign
any name you wish to each device. These names
Name (A1, A2, A3 etc). It is possible to assign
any name you wish to each device. These names
will be used later within the software in
Anonymous mode and are an easy way for you
Anonymous mode and are an easy way for you
to monitor which devices are registered.
Note: It is NOT possible to have NO Device
name.
Click into the Device Name field and type in a
suitable name that would uniquely identify the
suitable name that would uniquely identify the
device.