Redline Communications Inc. AN80IE ユーザーズマニュアル
&
User
AN-80i
Manual
70-00072-01-07
Proprietary Redline Communications © 2010
Page 32 of 106
Sept 18, 2008
HTTP Enable: Check this box
to enable the HTTP (Web) interface. If the option is
deselected, only CLI commands will be available.
Telnet Enable: Check this box
to enable a Telnet access (CLI) to the AN-80i. Refer
to the CLI commands in CLI Interface on page 66.
Telnet Port: Enter Telnet port address (default is 23).
SNMP Enable: Check this box
to enable the Simple Network Management Protocol
(SNMP) agent. When this item is checked, click on the blue text
[
Configure
SNMP
]
adjacent to the check box to display the SNMP Configuration screen.
Mgmt. Tag Enable: Check
this box to enable VLAN tagged traffic.
The Mgmt Tag Enable setting is disabled (factory default) when shipped from the factory
or following a long-reset operation. In this mode the PTP Master and PTP Slave can be
managed through the local Ethernet port using untagged traffic. Over-the-air
management is possible only after creating a pass-through group and pass-through
connections for each PTP Slave.
or following a long-reset operation. In this mode the PTP Master and PTP Slave can be
managed through the local Ethernet port using untagged traffic. Over-the-air
management is possible only after creating a pass-through group and pass-through
connections for each PTP Slave.
When Mgmt Tag Enable is enabled, this PTP Master or PTP Slave can be managed
only using VLAN traffic tagged with the value specified in the Mgmt. VID field. Over-the-
air management is possible only after creating a VLAN tagged group and VLAN tagged
connections for each PTP Slave.
only using VLAN traffic tagged with the value specified in the Mgmt. VID field. Over-the-
air management is possible only after creating a VLAN tagged group and VLAN tagged
connections for each PTP Slave.
It is recommended to create and test a VLAN group for tagged management traffic
before activating the Mgmt Tag Enable function. Set the associated QoS and priority
values to ensure management traffic has adequate priority and bandwidth during system
operation.
before activating the Mgmt Tag Enable function. Set the associated QoS and priority
values to ensure management traffic has adequate priority and bandwidth during system
operation.
Mgmt. VID: Enter the VLAN ID. When Mgmt. Tag Enable is selected, the system
recognizes only management commands with this VLAN ID.
recognizes only management commands with this VLAN ID.
Important: The VLAN network support should be verified before enabling this feature
to ensure the AN-80i system will be reachable using the VLAN tagged traffic.
to ensure the AN-80i system will be reachable using the VLAN tagged traffic.