Redline Communications Inc. SUIIRM ユーザーズマニュアル
Red
MAX
™
Subscriber Modem
SU-I User Manual
70-00078-01-02-DRAFT
Proprietary Redline Communications © 2008
May 12, 2008
Page 32 of 50
4.3.7 loadImage - Download and Activate Software Image
The loadImage command can be used to update the subscriber using the SMC channel
(via the base station Ethernet port) or using the local Ethernet connection.
(via the base station Ethernet port) or using the local Ethernet connection.
The following provides and example update session. The subscriber will reboot using the
new image automatically following a successful download.
new image automatically following a successful download.
Example Download Dialog with Subscriber
Login: admin
Password:
admin, welcome to the SS CLI.
SUI#> loadImage
Server IP Address:
Password:
admin, welcome to the SS CLI.
SUI#> loadImage
Server IP Address:
[enter ftp server IP address here]
File Name:
[enter binary file name here]
Opening FTP connection.....Done
Downloading image
............................................................................................………………
Done
Programming update........Done
Erasing setup partition. Done.
Writing setup partition. Done.
Erasing boot block. Done
Programming boot block. Done
Flash programming complete.
SUI#>reboot
Downloading image
............................................................................................………………
Done
Programming update........Done
Erasing setup partition. Done.
Writing setup partition. Done.
Erasing boot block. Done
Programming boot block. Done
Flash programming complete.
SUI#>reboot
4.3.8 modThresh - Modulation Threshold
Use the modulation threshold commands to view and adjust the settings for adaptive
modulation. These setting are made at the factory and should only be adjusted by
experienced personnel. The following table lists all commands available in this mode.
modulation. These setting are made at the factory and should only be adjusted by
experienced personnel. The following table lists all commands available in this mode.
Table 16: CLI - modThresh - Modulation Threshold Commands
Command
Description
reset
Set all parameters to factory default values. Requires confirmation.
set
Change parameter settings.
Rate1Exit: RW Rate 1 exit threshold. Value > 0
Rate1Entry: RW Rate 1 entry threshold. Value > Rate1Exit
Rate2Exit: RW Rate 2 exit threshold. Value > Rate1Entry
Rate2Entry: RW Rate 2 entry threshold. Value > Rate2Exit
Rate3Exit: RW Rate 3 exit threshold. Value > Rate2Entry
Rate3Entry: RW Rate 3 entry threshold. Value > Rate3Exit
Rate4Exit: RW Rate 4 exit threshold. Value > Rate3Entry
Rate4Entry: RW Rate 4 entry threshold. Value > Rate4Exit
Rate5Exit: RW Rate 5 exit threshold. Value > Rate4Entry
Rate5Entry: RW Rate 5 entry threshold. Value > Rate5Exit
Rate6Exit: RW Rate 6 exit threshold. Value > Rate5Entry
Rate6Entry: RW Rate 6 entry threshold. Value > Rate5Exit
Rate1Exit: RW Rate 1 exit threshold. Value > 0
Rate1Entry: RW Rate 1 entry threshold. Value > Rate1Exit
Rate2Exit: RW Rate 2 exit threshold. Value > Rate1Entry
Rate2Entry: RW Rate 2 entry threshold. Value > Rate2Exit
Rate3Exit: RW Rate 3 exit threshold. Value > Rate2Entry
Rate3Entry: RW Rate 3 entry threshold. Value > Rate3Exit
Rate4Exit: RW Rate 4 exit threshold. Value > Rate3Entry
Rate4Entry: RW Rate 4 entry threshold. Value > Rate4Exit
Rate5Exit: RW Rate 5 exit threshold. Value > Rate4Entry
Rate5Entry: RW Rate 5 entry threshold. Value > Rate5Exit
Rate6Exit: RW Rate 6 exit threshold. Value > Rate5Entry
Rate6Entry: RW Rate 6 entry threshold. Value > Rate5Exit