Advanced Control Technologies Inc. 0738-02 ユーザーズマニュアル

Z-Wave ZRR150 Instructions, Series 300, Rel. 2.1

010510

0738-02

1

The ZRR150 Duplex Receptacle is a component of the HomePro lighting control system.   Wire the Duplex Receptacle
in place of a standard receptacle according to the diagram above and program from the Wireless Controller to operate
loads.   Inclusion of this Receptacle on the ZTH100 Wireless Controller menu allows remote ON/OFF control of loads
connected to the controlled outlet.  The other outlet remains powered all the time.

This ZRR150 Duplex Receptacle is designed to work with other Z-Wave enabled devices.  Z-Wave nodes of other
types can be included in the system and will also act as repeaters if they support this function of repeating the signal
received, to other modules in the system.

This product supports 40Kbps data transmission.  This product can also be used for networking support in
systems that stream metadata. An example might include transmission of information from audio devices such as
song title, artist, and album information to various displays around the home.

As part of a Z-Wave network, the ZRR150 will also act as a wireless repeater to insure that commands intended for
another device in the network are received.  This is useful when the device would otherwise be out of the radio range
of the wireless controller.

There are no field repairable assemblies on this unit.  It is covered by a one year limited warranty.  If service is needed,
the unit must be returned where purchased.

DANGER!  SHOCK HAZARD.  Read and understand these instructions before installing.  This device is intended for
installation in accordance with the National Electric code and local regulations in the United States, or the Canadian
Electrical Code and local regulations in Canada.  It is recommended that a qualified electrician perform this installation.

Make sure the total load controlled does not exceed 1800 watts.  For indoor use only.  Retain instructions for future
use.

Wire this Receptacle in place of a current receptacle according to the diagram above. Use copper wire only, or the
equivalent.  See the ZTH100 Wireless Controller operating instructions to add this module under the command of the
Wireless Controller.

Note:  This module must be “Included
in the Network” only where it will be
permanently installed.  The proper
operation of  this node in the mesh
network is dependent on it knowing its
location with respect to other nodes.
You cannot “test bench” configure
this module, then install.

Controlled Outlet

Always Powered Outlet

•  This product supports Zensor Net Beam technology.