PNI Corporation IFS-11875 ユーザーズマニュアル
14
Setting up the compass
To set the compass readings you will need to drive your
vehicle slowly in a full circle. Be sure you are in an area
where you can safely perform this maneuver.
1. Install the radar detector in your vehicle at your
1. Install the radar detector in your vehicle at your
preferred location - windshield, dashboard, or visor.
2.
2.
Press and hold
the BACKLIGHT and MUTE buttons
simultaneously for 3 seconds.
3. The screen will display
3. The screen will display
“DRIVE IN A FULL CIRCLE...
PRESS ANY BUTTON WHEN DONE.”
4. Drive your vehicle in a full circle. The direction and size
of circle do not matter. You have one minute to
complete the maneuver.
5. Press any button to complete the compass set-up.
5. Press any button to complete the compass set-up.
Understanding alert messages
1. When a radar signal is detected, the screen displays
the name of the band –
“X”, “K”,
or
“KA”
– and a
number indicating the strength of the signal (1 to 8).
2. When a laser signal is detected, the screen displays
2. When a laser signal is detected, the screen displays
“LASER”
.
3. The higher the number, the stronger the signal.
4. Stronger signals usually mean the police radar/laser
4. Stronger signals usually mean the police radar/laser
device is relatively close; weaker signals usually mean
it’s farther away.
it’s farther away.
QUICK GUIDE