Vivato Inc. VLJ24WFSW ユーザーズマニュアル
132
Vivato 2.4 GHz Wi-Fi Switch User Guide
Command Line Interface
Enable Level Command Descriptions
add interface ethernet <0-3>
Enter the number of the Ethernet interface to add to the VLAN.
no add interface ethernet <0-3>
Enter the number of the Ethernet interface to remove it from the VLAN.
add interface wireless <1-13>
Enter the number of the wireless interface to add to the VLAN.
no add interface wireless <1-13>
Enter the number of the wireless interface to remove if from the VLAN.
add mac <mac address>
Enter the 12-digit hexadecimal medium access control (MAC) address of a device to allow
it to associate through this VLAN. Be sure to save your configuration after entering the
MAC addresses so that they are not lost if a reboot or power loss occurs.
it to associate through this VLAN. Be sure to save your configuration after entering the
MAC addresses so that they are not lost if a reboot or power loss occurs.
no add mac <mac address>
Enter the 12-digit hexadecimal medium access control (MAC) address of a device to
remove it from the VLAN.
remove it from the VLAN.
aging-time <10-1000000>
Set the forwarding entry aging time in seconds.
default
Enter this command to make this the default VLAN.
no default
Enter this command to not use this VLAN as the default VLAN.
DHCP Operation
Refer to the bridge interface’s DHCP command descriptions for DHCP operation on any
interface. See
interface. See
exit
Stop configuring this VLAN.
Important After being created, a VLAN it is not enabled until the
command is issued. Use
the
to display the current status of a VLAN.