Vivato Inc. VLJ24WFSW ユーザーズマニュアル

By default, wireless interfaces are bridged (using br0) to the Ethernet 0 (eth0) and 
Ethernet 1 (eth1) interfaces for wireless clients to be able to access the wired network. 
See 

on page 124.

Enter a channel number for the wireless interface. The value must be in the range of 1 to 11. 
Channel assignments are automatically “mirrored” across the face of the Wi-Fi Switch. 
Therefore, any time you change a wireless interface channel (other than wlan13’s channel) 
the channel assignment of the corresponding wireless interface on the opposite side of the 
Wi-Fi Switch is changed to match. The colors shown below illustrate the mirrored channel 
settings.

Refer to the bridge interface’s DHCP command descriptions for DHCP operation on any 
interface. See 

on page 125.

Important Under most circumstances, the default channel assignments shown above should be used, 

especially when using the Wi-Fi Switch in areas of heavy Wi-Fi traffic. Channel 6 can be used 
to provide three channel operation (along with channels 1 and 11) when Wi-Fi traffic is light.

wlan9

wlan2

wlan11

wlan4

wlan7 wlan1

wlan13 wlan6

wlan10 wlan3

wlan12

wlan5

wlan8

100°

Channel

1

11

1 

11

1

11

1

11

1

11

11

1

1

Channel assignments are mirrored. For example, if you change the channel 
of wlan11, the channel for wlan12 is automatically set to the same channel.

Vivato Wi-Fi Switch (Top View)