Vivato Inc. VLJ24WFSW ユーザーズマニュアル

Enter the RADIUS authentication server name, port number, and its secret to disable 
authentication through that server.

Disable the IP addresses that can be assigned to wireless clients, either as an individual IP 
address or as a contiguous range, such as 1.2.3.10-50.

These commands enable and disable rogue access point detection (RAPD). RAPD looks for signals 
from Wi-Fi access points within the coverage area of the Vivato Wi-Fi Switch. These access points 
can interfere with the operation of the Wi-Fi Switch, and should be removed or be re-configured to 
operate on non-interfering channels. To view a list of detected access points, use the 

 

command.

Enable rogue access point detection. The default state is disabled.

Disable rogue access point detection.

The following commands are used to configure simple network management protocol (SNMP) 
operation.

Enables the SNMP daemon. The default state is disabled.

Enter the name of an SNMP community to create and whether it allows read only (RO) or 
read-write (RW) operation. If the [

 option is used, only SNMP requests 

from the source IP address are honored.

Enter text for system contact information, such as a person’s name.

Enter an SNMP engine identifier (ID). An engine ID can only be created if there are no SNMPv3 
users. Use the 'no snmp-server user' command to remove all users if you have any defined. Only 
hex characters (0-9 and a-f) can be used to define an SNMPv3 engineID.