Young Electronics Corporation. EMS1YOUNG ユーザーズマニュアル

Top Case Removed

Transmitter with

according to the exact code setting of your previous transmitter

3. Using a sharp object or tool, such as a paper clip, set the new

transmitter code by setting the "ON" and "OFF" switches

case and carefully separate the case halves to expose

the circuit board and battery.(See Diagram #1)

2. Remove the two Philips head screws located on the back of the

possible for you to choose from.

However there are over hundreds of combinations of codes

transmitter or the receiver.

1. Determine the 10 digit access code obtained from the previous

OPERATING INSTRUCTIONS:

ACCESS 300 mini Transmitter

Code Setting

the following sequences are not recommended.

DISTRIBUTED BY

TORRANCE CALIFORNIA

2. Stand in several different areas of usage to locate possible

points where certain structures may interfere with

push the transmitter button to activate.

1. Standing approximately 10-30 feet away from the receiver,

It is important for the access code to be set exactly in the same

order as the receiver for the transmitter to function properly.

Setting the switch on all "ON" or all "OFF" position.

Alternating from "ON" and "OFF" or "OFF" and "ON" position.

DIAGRAM #1

ACCESS-300

Battery

the transmission.

Testing the Transmitter

Note: In order to avoid duplication of your access code,

4. Once the codes have been set, replace the top cover,

or the receiver.(Note: The switches are in the "ON" positions

when the switch is pushed toward the letter ON.)

and test the system.

(See Diagram #2)

DIAGRAM #2

Code Switch

with the limits for a Class B digital device, pursuant to

NOTE: This equipment has been tested and found to comply

part 15 of the FCC Rules. These limits are designed to

interference in a residential installation. This equipment

provide reasonable protection against harmful

communications. However, there is no guarantee that

instructions, may cause harmful interference to radio

and, if not installed and used in accordance with the

generates,uses and can radiate radio frequency energy

encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment

radio or television reception, which can be determined
by turning the equipment off and on, the user is

If this equipment does cause harmful interference to

interference will not occur in a particular installation.

- Connect the equipment into an outlet on a circuit

and receiver.

different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV

technician for help.

of this device which are not expressly approved by the

Caution: Any changes or modifications in construction

party responsible for compliance could void the user's
authority to operate the equipment.

1. Output Power : -37dBm
2. Output Frequency : 300MHz

General specfication & Feature

4. Operation Indicate LED Lamp

3. Power Supply : 12Vdc(5Vdc Regulation)

5. Lighting LED Lamp

J ELECTRONICS & CO.

PRODUCT INSTRUCTION

door opener and gate operators for home,farm and ranch etc...

The,ACCESS300, is the mini transmitter designed for the garage

Code Switch

DOOR BUTTON
OPERATION
INDICATOR

LIGHT
This LED lamp helps
you see the key lock.

DOOR(GATE)
Open/Close

TRANSMITTER BUTTONS

QUICK REFERENCE FOR

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause

received, including interference that may cause undesired operation.

harmfull interference, and (2) this device must accept any interference