Zagg ZKSM ユーザーズマニュアル
automatically reconnect with the tablet. If
pressed again
pressed again
GREEN
LED will turn on 2 seconds
then off indicating it is still ON.
Power Off
Red
LED under
power key
The
RED
LED will blink twice then turn OFF
indicating the keyboard is OFF when the power
key is pressed and held down for 3 second.
When power is turned OFF the keyboard with
disconnect BT.
key is pressed and held down for 3 second.
When power is turned OFF the keyboard with
disconnect BT.
Charging
Red
LED under
power key
RED
LED stay ON until Battery cell is full Charged.
Low power
Red
LED under
power key
When battery reaches a Charge level (12%~24%)
the back lightning will be disabled and when
Critical Level is achieved (0%~11%) a
the back lightning will be disabled and when
Critical Level is achieved (0%~11%) a
RED
LED
will flash three times, one flash sequence every 5
minute. (1 Hz Flash 50% Duty)
minute. (1 Hz Flash 50% Duty)
Bluetooth Pairing
Blue
LED under
power key
Push and hold Pairing key for 3 seconds for
pairing. A
pairing. A
BLUE
LED under power key will Flash
when pairing. Flash will stop flashing when
paired. Pairing times out after 60 sec.
paired. Pairing times out after 60 sec.
• Caps Lock:
Function
LED Colour
Remark
Caps Lock ON
Blue LED under
Caps Lock Key
Caps Lock Key
LED Stay on until key is pressed again
• Tablet Bluetooth Display
Function
Name
Remark
Display in Bluetooth
settings
settings
ZAGG Basic Folio
Zagg Basic will show in the display of Bluetooth
devices the tablet detects
devices the tablet detects
Note: Now the turning ON and OFF of the keyboard through the key frame is really only
toggling between Hibernation Mode and Active Mode and disconnecting Bluetooth
connection when in Hibernation Mode.
To perform a HARD RESET, a micro USB cable needs to be plugged into a 5V power source
and then plugged into the keyboard. A GREEN LED under the power key will come on for 2
seconds then changes to RED indicating the PCBA has been reset.
For all flashing of LED’s a flash cycle time 1 Hz Flash 50% Cycle will be used.
toggling between Hibernation Mode and Active Mode and disconnecting Bluetooth
connection when in Hibernation Mode.
To perform a HARD RESET, a micro USB cable needs to be plugged into a 5V power source
and then plugged into the keyboard. A GREEN LED under the power key will come on for 2
seconds then changes to RED indicating the PCBA has been reset.
For all flashing of LED’s a flash cycle time 1 Hz Flash 50% Cycle will be used.
3.5. RF Specifications
Simple data transmitter operation at 2.4GHz range