3e Technologies International Inc. 523E-900 ユーザーズマニュアル
AirGuard WiMesh 3e-
523 Series User’s Guide
Copyright
2015 Ultra Electronics, 3eTI
October 2015
30
29000169-005 Revision C1
Figure 21 - Wireless Bridge - Manual Bridging
Table 5 - Manual Bridging General Settings Options
Manual Bridging General Settings Options
Bridging Mode
Manual Bridging
manual bridging selected
Signal Strength
LED MAC
LED MAC
Not Assigned
Allows you to set the number of the
remote AP which will be listed at the
bottom of the screen once the
system is operational This wireless
bridge becomes the guiding port
that is displayed in the WLAN LED
on the front of the 523
remote AP which will be listed at the
bottom of the screen once the
system is operational This wireless
bridge becomes the guiding port
that is displayed in the WLAN LED
on the front of the 523
–3 and
3e-523-F1 as a signal.
Spanning Tree
Protocol (STP)
Protocol (STP)
Enable/Disable
Enable STP if there is any
possibility that a bridging loop could
occur. If you are certain that there is
no possibility that a bridging loop
will occur, then disable STP. The
bridge will be more efficient (faster)
without it. If you are not sure, the
safest solution is to enable STP.
possibility that a bridging loop could
occur. If you are certain that there is
no possibility that a bridging loop
will occur, then disable STP. The
bridge will be more efficient (faster)
without it. If you are not sure, the
safest solution is to enable STP.
Remote AP's
MAC Address
MAC Address
Read Only
Displays the BSSID of remote
bridges that were added on the
Wireless Bridge - Radio screen.
bridges that were added on the
Wireless Bridge - Radio screen.