3e Technologies International Inc. 527A3 ユーザーズマニュアル

Next go to the Wireless Bridge — General screen. Select either 

manual or auto bridging.  If you choose Manual Bridging then you will 

have to set Spanning Tree Protocol to Enable unless you are sure that 

there is no chance of a loop. You can also assign a Signal Strength LED 

. Signal strength LED MAC allows you to set the number of one of 

the Remote APs which will be listed at the bottom of the screen once the 

system is operational as the guiding port that you wish to have display in 

the WLANSS LED on the front of the 3e–527A3 as a signal. If you don’t 

assign one, the LED will show the upper link signal strength (if there is 

one). From this screen you can also choose to delete a remote AP's MAC 

address.

Click Apply to accept your changes.

If you choose Auto Bridging mode, then you will need to enter the 

follwoing information:

Enter the SSID. This can be any set of letters and numbers assigned 

by the network administrator. This nomenclature has to be set on the 

wireless bridge and each wireless device in order for them to communi-

cate.

Enter a number from 1 to 40 for the Max Auto Bridges. Next enter the  

 (range from 1-40). This determines the root STP node. The 

lowest bridge priority in the network will become the STP root.

Select the Signal Strength Threshold. 
Either enable or disable the Broadcast SSID. When disabled, the 

bridge hides the SSID in outgoing beacon frames and stations cannot 

obtain the SSID through passive scanning. Also, when it is disabled, the 

bridge doesn’t send probe responses to probe requests with unspecified 

SSIDs.

Finally enter the Signal Strength MAC. The signal strength of this