AeroComm Corporation PKLR2400-200 ユーザーズマニュアル
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
AC5124-10 Specifications
11/24/03
27
5.1.10
5.1.10
5.1.10
5.1.10 Acknowledge
Acknowledge
Acknowledge
Acknowledge
A transceiver issues this command in response to some of the Host commands indicating a positive
response. The
response. The
Acknowledge
Acknowledge
Acknowledge
Acknowledge consists of the Host command sequence with a zero length, unless
otherwise noted.
5.2
5.2
5.2
5.2 TTTT
RANSCEIVER
RANSCEIVER
RANSCEIVER
RANSCEIVER
C
C
C
C
OMMAND
OMMAND
OMMAND
OMMAND
S
S
S
S
ET
ET
ET
ET
The Transceiver Commands allow the OEM to control the flow of data into and out of a transceiver as
well as initialization of a transceiver. The table below summarizes the commands.
well as initialization of a transceiver. The table below summarizes the commands.
Table
Table
Table
Table 5555 - Transceiver Command Set
- Transceiver Command Set
- Transceiver Command Set
- Transceiver Command Set
Name
Name
Name
Name
Command
Command
Command
Command
Length
Length
Length
Length
Low
Low
Low
Low
Low
Length
Length
Length
Length
High
High
High
High
High
Data
Data
Data
Data
Checksum
Checksum
Checksum
Checksum
RF Enable
80h
00h
00h
No Data
80h
Send Data
81h
0Ch – 7FBh (includes
802.3 Header)
802.3 Header)
As Required
As Required
Send Data Complete 82h
01h
00h
00h or 01h (See
Section 5.2.3, Send
Section 5.2.3, Send
Section 5.2.3, Send
Section 5.2.3, Send
Section 5.2.3, Send
Data Complete
Data Complete
Data Complete
Data Complete
Data Complete)
As Required
Received Data
83h
0Ch – 7FBh (includes
802.3 Header)
802.3 Header)
As Required
As Required
In Range
84h
06h
00h
IEEE 802.3 address of
Server
Server
As Required
Out of Range
85h
00h
00h
No Data
85h
5.2.1
5.2.1
5.2.1
5.2.1 RF Enable
RF Enable
RF Enable
RF Enable
The Host issues this command to a transceiver prior to any RF data transfers. The Host typically issues
this command after resetting a transceiver. This enables the RF interface of a transceiver and turns the
transmitter/receiver ON. The Host must wait for the
this command after resetting a transceiver. This enables the RF interface of a transceiver and turns the
transmitter/receiver ON. The Host must wait for the
Acknowledge
Acknowledge
Acknowledge
Acknowledge command before issuing any
additional commands. Ensure that only one RF Enable command is issued following a Reset.
Example: 80|00|00|80 (There are no Data bytes for this command)
Acknowledge: 80|00|00|80