AeroComm Corporation PKLR2400-200 ユーザーズマニュアル

AC5124-10 Specifications

11/24/03

7.1.19.5

7.1.19.5 Auto Destination

Auto Destination

EEPROM Address: 4Fh, bit 7
Length: 1 Bit
Default: 0
Range: 0 or 1

The AC5124 supports an addressed mode of communication called Auto Destination. This mode is
only for Clients operating in one of the Transparent Modes. To configure a Client for Auto Destination,
set this bit to a value of 1. With Auto Destination enabled, a Client has the ability to detect any Server
with the same Channel and System ID. Therefore, a Client can dynamically route all communications
to the Server that is in range. This mode is useful for mobile or roaming applications where a Client will
be interfacing with different Servers from time to time. It is important to note that multiple Servers with
the same Channel and System ID must not be located in range of one another. Doing so will cause
inoperability of the system.

7.1.20

7.1.20 Destination IEEE MAC Address

Destination IEEE MAC Address

EEPROM Address: 50h
Length: 6 Bytes
Default: FF FF FF FF FF FF
Range: 00h – FFh for each byte

The Destination IEEE MAC Address is used by transceivers operating in any Transparent Mode with
Addressed Mode (EEPROM address 4Bh = 00h) enabled. When this address is programmed to an
actual transceiver address, RF-layer acknowledgements will be used to guarantee packet delivery. If
the address is left programmed to the default value, all packets sent will be considered broadcast
packets without RF-layer acknowledgements. If Auto Destination is enabled, RF layer
acknowledgements will be used. See Section 4.6, Addressed & Broadcast Communication

Section 4.6, Addressed & Broadcast Communication

Section 4.6, Addressed & Broadcast Communication for more

details on using this parameter.

7.1.21

7.1.21 Sleep Time

Sleep Time

EEPROM Address: 7Ah
Length: 3 Bytes
Default: 00 00 0A
Range: 00h – FFh, 200ms increments

Sleep Time is used by Client transceivers programmed to operate in Sleep Walk Mode, described in
Section 6.1.13.3.1, Sleep Walk Mode

Section 6.1.13.3.1, Sleep Walk Mode

Section 6.1.13.3.1, Sleep Walk Mode. Each increment in the value of this byte will cause a Client to
remain asleep 200ms longer.

7.1.22

7.1.22 Wait Time

Wait Time

EEPROM Address: 7Dh
Length: 3 Bytes
Default: 00 00 20
Range: 00h – FFh, 200ms increments

Wait Time is used by Client transceivers programmed to operate in Sleep Walk Mode, described in
Section 6.1.13.3.1, Sleep Walk Mode

Section 6.1.13.3.1, Sleep Walk Mode

Section 6.1.13.3.1, Sleep Walk Mode. Each increment in the value of this byte will cause a Client to
remain awake 200ms longer.