Capital Prospect Ltd AM001 ユーザーズマニュアル
10. Activate the sensor, the control panel will beep and you will hear “Zone _ Sensor _
Accepted” if the sensor is programmed, the [PROG] LED will be off. To program another
sensor, repeat the above steps.
sensor, repeat the above steps.
ote: If an occupied sensor location is selected, the new sensor will replace the old one.
dditional keychain or keypad remote can be programmed to the control. You may also
odel SW-100R or Garage
e programmed
the control panel.
Receivers should be programmed to Device 1 to Device 5.
ll
1.
2.
2.
panel will emit 3 beeps if the valid password is
ente
,
3. Enter [4]
arn Keychain / Receiver”. Notice all 5 zone LEDs, some of
them a
flashing
flashing
N
Learn Remote / Receiver
A
program additional receivers such as the Light Switch Receiver, M
Door Receiver GD-101R. Maximum of 5 keychain remotes and 5 receivers can b
to
•
•
Keychain or keypad remote should be programmed to Device 6 to Device 0.
ow the instructions below to program remotes / receivers.
Fo
Press the [PROG] button on the side of the control panel, the [PROG] LED will be on.
Enter the current Master Password. Control
Enter the current Master Password. Control
red otherwise a single long beep will be emitted and [PROG] LED will be off.
, which represents “Le
m y be off, some of them may flash once, some of the may flash twice. The LED
represents the occupied sensors.
•
If the zone LED remains off, that indicates that zone is not occupied by any
keychain / receiver.
keychain / receiver.
•
If the zone LED flashes once, that indicates a receiver has occupied that device.
Zone 1 LED flashes once means Device 1 is occupied.
Zone 1 LED flashes once means Device 1 is occupied.
•
If the zone LED flashes twice, that indicates a keychain / keypad remote has
occupied that zone. Zone 1 LED flashes twice means Device 6 is occupied.
occupied that zone. Zone 1 LED flashes twice means Device 6 is occupied.
For programming a receiver, select a device number from Device 1 to Device 5.
Press and
4.
ce on
5.
selected, that zone LED will be on steadily.
You
can now transmit a signal by pressing one of the buttons from the keychain
.
. The control panel will beep and you will hear “Device X Accepted” if the device is
programmed and the [PROG] LED will be off. To program another remote / receiver, repeat
hold the learn button on the receiver continuously, you will see the LED flashing rapidly. To
select device 1, press button 6. The LED stop flashing indicate the receiver has received
the signal.
select device 1, press button 6. The LED stop flashing indicate the receiver has received
the signal.
Then press button 1 on control panel for device 1.
Once a device is selected,
that zone LED will be on steadily. .
You can now transmit a signal by pressing on
learn button on the receiver
.
For programming a keychain, select a device number from Device 6 to Device 0. To select
device 6, press button 6. Once a device is
device 6, press button 6. Once a device is
6
the above steps.
Note: If an occupied device is selected, the new sensor will replace the old one.