Capital Prospect Ltd AM001 ユーザーズマニュアル

 

feature was disabled for all zones at the factory. 

This 
 
To en le 
 
1. 

Press

e [PROG] LED will be on. 

2. 

is en

D will be off. 

ab event trigger, follow the instructions below. 

 the [PROG] button on the side of the control panel, th

Enter the current Master Password.  Control panel will emit 3 beeps if the valid password 

tered, otherwise a single long beep will be emitted and [PROG] LE

3. 

Enter [7], which represents “Event Trigger” setting.  Notice all 5 zone LEDs, some of them 
may be off, some of them may flash once, some of them may be on steadily.  The LED 
flashing represents the current event trigger setting.   

• 

If the zone LED is off, that indicates event trigger is disabled. 

• 

If the zone LED flashes, that indicates event trigger is enabled, and it will turn off the 
corresponding device when the sensor(s) is activated 

• 

If the zone LED remains steadily on, that indicates event trigger is enabled, and 
turn 

it will 

on the corresponding device when the sensor(s) is activated 

. 

To change the event trigger setting, press buttons 1 to 5 will d
zones.  P ssing buttons 6

 event trigger for those zones.  However, even 

this feature is enabled, you still have to select whether you want to turn that device on or 
off when the sensor(s) is trig

ssing buttons [6] to [0] will toggle the setting 

between on and off.  For exa

 LED is currently

vent trigger for zone 2 

is enable with the Off signal, you can press button [7] to change it to the On signal.  
Pressing [7] again will change it back to Off signal.  Refer to Fig X.  After making the 
change, notice the status of the zone LED changes as w

 

4

isable event trigger for those 

re

 to 0 will enable

gered.  Pre

mple, if the

 showing e

ell.   

 

Button [1] 

Button [6] 

Button [2] 

Button [7] 

Button [3] 

Button [8] 

Button [4] 

Button [9] 

Button [5] 

Button [0] 

 
5. 

You are allowed to make unlimited changes before programming is quit.  Once you are 
satisfied with the settings, press [PROG] to quit programming and the settings will be 

ote: If event triggered is enabled for a door sensor, which turn lights on when it is open, this 

ave 

n operate in 2 different modes, 1) Alert Mode, 2) 

nd immediately (with instant 

 not want to trigger the alarm when the system 

saved. 

 
N
feature will not be activated during exit delay.  Since during exit delay, users suppose to le
the premises and therefore lights will not be turned on.   However, if the event triggered is 
enabled to turn lights off, it will be activated during exit delay. 
 
 

 
As explained earlier, the control panel ca
Security Mode.  In security mode, when a sensor is triggered, the control panel will need to be 
disarmed either after 30 seconds (with entry delay), or siren will sou
alarm).  However, there are sensors that you do