Alvarion Technologies Ltd. BMAX-BA36 ユーザーズマニュアル
90
Operation
Chapter 4 - Operation and Administration
4.2
The Monitor Program
4.2.1
Accessing the Monitor Program
1
Use the Monitor cable to connect the MON connector of the NPU to the COM
port of your ASCII ANSI terminal or PC. The COM port connector on the
Monitor cable is a 9 pin D type plug.
port of your ASCII ANSI terminal or PC. The COM port connector on the
Monitor cable is a 9 pin D type plug.
2
Run a terminal emulation program, such as HyperTerminal™.
3
Set the communication parameters as shown in the following table:
4
The password prompt is displayed. Enter the password and press the Enter
key to get to the Main menu.
key to get to the Main menu.
To access the Monitor program via the MON connector:
Table 4-1: COM Port Configuration
Parameter
Value
Baud Rate
9600
Data Bits
8
Stop Bits
1
Parity
None
Flow Control
Xon/Xoff
Port
Connected COM port
NOTE
There are 3 access levels, as described in
Section 4.2.2
. The default password for each of the
access levels is:
Access Level
Default Password
Administrator
admin
Installer
installer
Monitor
monitor