ATAG DX6211L ユーザーズマニュアル
147
Induction Hob Installation
Induction Hob Installation Guide
Installation Requirements
ATAG Induction hobs have air vents on the under side
of the appliance, at the front and bottom. To allow the
hob to vent from the front a 3 mm gap is recommended
between the bottom of the work surface and the top
of a drawer front or ATAG 600 mm Single Oven that is
installed beneath the hob.
Please see the diagram below:
If an ATAG Induction Hob is installed in an extra deep
work surface or in a handleless kitchen the hob will
automatically vent from the bottom.
Please see the diagram below:
Under these circumstances if there is limited space
beneath the hob, due to a drawer or single oven
installation, it is recommended that ‘air holes’ be cut into
the cabinetry directly beneath (to the left, right and rear)
of the hob.
Additional Ventilation/Heat protection
When installing an ATAG Induction Hob above an ATAG
600 mm Single Oven it is not necessary to provide
additional ventilation space or heat protective shields
beneath the hob/above the oven.
Please note that when an ATAG Induction Hob is
installed above an ATAG 900 mm Single Oven additional
ventilation space and heat protective are required, refer
to the User Care/Installation Guide for more information.
Air Flow/Direction
Please see the diagram
below for the required air
flow/direction when an
ATAG Induction Hob is
installed above a drawer:
Please see the diagram
below for the required air
flow/direction when an
ATAG Induction Hob is
installed above an ATAG
600 mm Single Oven:
3 mm