Z Com Inc XG621 ユーザーズマニュアル
FCC STATEMEMT:
This device is intended only for OEM integrators under the
following conditions:
1) The antenna must be installed such that 20 cm is maintained
following conditions:
1) The antenna must be installed such that 20 cm is maintained
between the antenna and users, and
2) The transmitter module may not be co-located with any other
transmitter
or antenna.
As long as 2 conditions above are met, further transmitter test will
not be required. However, the OEM integrator is still responsible for
testing their end-product for any additional compliance
requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
not be required. However, the OEM integrator is still responsible for
testing their end-product for any additional compliance
requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions can not be
met (for example certain laptop configurations or co-location with
another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization
another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization
.
End Product Labeling
This transmitter module is authorized only for use in device where
the antenna may be installed such that 20 cm may be maintained
between the antenna and users (for example access points, routers,
wireless ADSL modems, and similar equipment). The final end
product must be labeled in a visible area with the following:
"Contains TX FCC ID: M4Y-XG621".
the antenna may be installed such that 20 cm may be maintained
between the antenna and users (for example access points, routers,
wireless ADSL modems, and similar equipment). The final end
product must be labeled in a visible area with the following:
"Contains TX FCC ID: M4Y-XG621".
Manual Information for End Users
The end user must not have manual instructions to remove or
install the device. The user manual for end users must include the
following information in a prominent location:
install the device. The user manual for end users must include the
following information in a prominent location:
"IMPORTANT NOTE:
To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter
must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter."
must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter."