Z Com Inc ZAC10235 ユーザーズマニュアル
33
WAN Access Type:
Specify the Internet access method to Static IP, DHCP or PPPOE. Users must enter WAN IP
Address, Subnet Mask, Gateway settings provided by your ISPs.
LAN Settings:
When DHCP Server is disabled, users can specify IP address and subnet mask for the Access
Point manually. Make sure the specified IP address is unique on your network in order to prevent
IP conflict. When DHCP Server is enabled, users may specify DHCP IP Address Range, DHCP
Subnet Mask, DHCP Gateway and Lease Time (15-44640 minutes). A DHCP relay agents is
used to forward DHCP requests and replies between clients and servers when they are not on the
same physical subnet. To enable the DHCP relay agent, check the “Enable DHCP Relay”
checkbox and enter the IP address of the DHCP server.
In AP mode, the IEEE 802.11n Wireless Access Point must establish connection with
another wireless device before it is set to Router mode. To access the unit in Router
mode via wired port, please type the WAN IP address to enter the web page for WAN
is on wired port and LAN is on wireless port. Or, you can access device through the
wireless device connected with the Access Point.
In wireless client mode, users can access the Access Point via its wired port, for WAN
is on wireless port and LAN is on wired port when device is set to Router mode.
Bridge mode and AP Repeater mode are similar to AP mode when device is set to
Router mode; WAN is on wired port and LAN is on wireless port. Thus users must also
connect the Access Point with another wireless device before it is set to Router mode
and access the Access Point via the connected wireless device.
Time Settings
Compliant with NTP, the IEEE 802.11n Wireless Access Point is capable of keeping its time in
complete accord with the Internet time. Make configuration in “Time Settings” from “System”. To use
this feature, check “Enable NTP Client Update” in advance.
Warning: