Parallels Workstation 2.2, 10-24u, IT, MNT WWL2XM-02-IT ユーザーズマニュアル

If you encounter any sort of problems with networking inside a virtual machine, varying from 
inability to access Internet to host-only network configuring failure, that can not be handled by 
adjusting virtual machine and Parallels Workstation settings, we recommend that you check 
your primary OS firewall settings. The primary OS firewall may affect Parallels Host-Guest 
Virtual NIC (page 132) network adapter thus preventing host-only network functioning. It also 
may interfere Bridged Ethernet networking. 

 

To run an Ubuntu Linux 6.0.6 Server in a virtual machine, follow these steps: 

1  The virtual machine should have the network adapter included into its' configuration. 

Network adapter should be set to the Bridged Ethernet mode. 

If you use a typical virtual machine, it meets both conditions. 

2  Install the Ubuntu Linux 6.0.6 Server package. Do not disconnect the installation CD/DVD 

or its' image! 

3  Make sure that Boot Sequence on the Configuration Editor / Options / Booting Options tab is 

set to [CD-ROM, Hard Disk, Floppy]. 

4  Power on the Ubuntu virtual machine. Enter  

in the prompt. 

5  In the Enter rescue mode screen select /dev/discs/disco/part1, then on the same screen, select 

execute a shell in /dev/discs/disco/part1. Note that these options may have slightly different 
names. 

6  In the next screen click Continue. 

7  In the prompt string enter the following command: 

8  When you are asked if you want to continue, type "y". 

9  686 kernel is downloaded and installed. When it is finished, enter the 

command. 

10  In the Enter rescue mode screen select the last option reboot the system.  

11  Disconnect the installation CD/DVD from your virtual machine to boot from hard disk. 

After booting is finished the virtual machine is ready for work.