Identiv Inc SDI010MOD02 ユーザーズマニュアル
SDI010-MOD OEM Integration Manual v1.0
Page 4 of 4
3. Device appears with yellow bang (!) on device manager
This could happen when drivers are not found for this device or when drivers fail
to load. The drivers for this device are available on Windows Update or can be
downloaded from
to load. The drivers for this device are available on Windows Update or can be
downloaded from
http://www.scmmicro.com
. If the failure is due to driver load
failure, then the reason for driver load failure can be inferred from the device
manager message at the General tab.
manager message at the General tab.
4. Contact less cards are not detected
This could happen when module is placed in proximity to something made out of
metal. Ensure that there is not metal in proximity between the antenna and the
card.
metal. Ensure that there is not metal in proximity between the antenna and the
card.
5. Contact card is not detected
Check the connections on the two pin header. The terminals should be continuous
when a card is inserted.
when a card is inserted.
6. Contact card cannot be read
Ensure that the cables between (both five and four pin) headers and the smart card
connector are of same length and type.
connector are of same length and type.
DISCLAIMER
The module has been tested and determined to be compliant with the FCC rules for
intentional radiators.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
intentional radiators.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.