CyberTAN Technology Inc. WD112 ユーザーズマニュアル

FCC Statement: 

Federal Communication Commission Interference Statement 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guarantee that interference 

will not occur in a particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one of the following measures: 

●   

Reorient or relocate the receiving antenna. 

●   

Increase the separation between the equipment and receiver. 

●   

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

●   

Consult the dealer or an experienced radio/TV technician for help. 

 
 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

 
 

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of 

other channels is not possible. 

 
 

This device and its antenna(s) must not be co-located with any other transmitters except in accordance with 

FCC multi-transmitter product procedures. 

Refering to the multi-transmitter policy, multiple-transmitter(s) and module(s) can be operated simultaneously 

without C2P.