Cross Point b.v. CP321AMD ユーザーズマニュアル
NEXUS AM Deactivator
Configuration
v2.1
Page 17 of 26
7.2
Synchronization
When AM systems or AM deactivators are installed in relative close vicinity of each other,
it is of extreme high importance that the transmission bursts of all transmitters
(transceivers) occur at the same moment. To be able to view and change the position of
these transmission bursts, the Synchronization screen is available.
it is of extreme high importance that the transmission bursts of all transmitters
(transceivers) occur at the same moment. To be able to view and change the position of
these transmission bursts, the Synchronization screen is available.
When the Synchronization screen is open, the transmission burst of this
deactivator is disabled. As a result of this, the deactivator will not detect
any labels! Make sure to leave this screen to enable detection and
deactivation of labels again.
deactivator is disabled. As a result of this, the deactivator will not detect
any labels! Make sure to leave this screen to enable detection and
deactivation of labels again.
When the transmission bursts are not synchronized properly, unwanted deactivations and
reduced sensitivity will be the result. The Synchronization screen will show exactly if and
where other system transmission bursts are detected.
reduced sensitivity will be the result. The Synchronization screen will show exactly if and
where other system transmission bursts are detected.
Figure 10: Synchronization
We now have two ways of synchronizing the systems; manually or automatically.
It is advised to tilt the deactivator in a vertical position when
synchronizing the unit, as it will detect other AM systems and
deactivators better, making it easier to properly synchronize all AM
devices.
synchronizing the unit, as it will detect other AM systems and
deactivators better, making it easier to properly synchronize all AM
devices.