TOYO ELECTRIC MFG. CO. LTD. TY-16F ユーザーズマニュアル

 

 

Operating Instructions 

•  Read enclosed Safety Instruction Sheet before starting.   
•  Remove the lights, remote control and battery from the packaging and follow the instructions below.  

 

 

1.  Remove the remote control and battery from the plastic bag. 

2.  Open the battery cover on the back of the remote by sliding the cover towards the bottom of the remote 

3.  Clean the battery contacts and also those of the device prior to battery installation. 

4.  Use only same type 23A, 12V Alkaline battery for replacement, use of other batteries may damage remote. 

5.  Insert negative (-) end of the battery (see marking on battery) into the spring side of the battery holder and insert positive (+) end of 

the battery into other side. 

6.  Close battery cover by sliding back into place. 

         

  

       

         

 

 

The remote has three buttons on the front side to operate the 16 Function remote controlled set: 

a.  POWER –    – This is the larger button at the top.  Press to turn the lights OFF.  Press again to turn the lights ON.     Note:  

Even when the lights are off, the set still has power to all lamps, to disconnect power, you must unplug the set. 

b.  FUNCTION – This is a smaller button in the middle.  Press to change the light pattern to the next function mode.  In 

addition to the list below, the light patterns are also listed on the back side of the remote.  After reaching function 16, the 
set will return to Function 1 by pressing the function button again.  For best results, pause for a few seconds before 
pushing the “FUNCTION” button again for the next function. 

c.  SYNC – This is a smaller button located on the bottom of the remote.  This button is used if you have multiple sets of the 

Philips 16 function lights with remote control. This button allows you to synchronize all your sets to the same function by pressing the 
button as long as all light sets are illuminated (sets do not have to be connected to the same outlet, they only need to be within range 
of the remote). 
TIP – If you want to return the set (or sets if you have more than one) back to Function 1 (steady on white) at any time, just push both 
the “FUNCTION ” and “SYNC” buttons at the same time for about 2 seconds until the set returns to steady white color.  This resets the 
unit back to Function 1 so you can start over and in case you are not sure which function you are on. 

 
The light set when used in conjunction with the remote control has 16 different lighting patterns and functions. To change the functions and 
patterns of the light set you must use the remote control, so it is important to keep it in a safe place. 
 
The remote will work though most windows and walls, and does not require a line of sight between the remote and light string, so you can 
comfortably use the remote inside your home to change your lights if used outdoors. 

+

   ‐