Gain Electronic Co Ltd 12BP12 ユーザーズマニュアル
Follow the procedures below when finish operation
1. Press EMS button
2. Switch rotary key to “OFF” position
3. Remove rotary key and keep in a safe place
4. Remove batteries if not to be used for long period of time.
Transmitter LED Indicator
Note: Switch rotary key to “OFF” position to turn off transmitter completely
thus extend battery life, otherwise transmitter is in standby mode when
rotary key remain in “ON” position.
Changing Receiver Input Voltage
If the factory preset receiver voltage is different from application, follow the
procedures below to change input voltage.
1. Switch off receiver main power.
2. Remove the connector from original position.
3. Insert connector to new voltage position accordingly.
Troubleshooting
A. When transmitter red LED flash fast continually, it may be
1. One of pushbutton jammed.
2. EMS button is not disengage
3. Fail to follow Power-on procedures accordingly.
B. When transmitter red LED flash slowly, it may be low battery power.
Green (Full Power)
Operate as usual.
Yellow (Mid Power)
Unload the article as soon as possible and stop operation until
new batteries are replaced.
Red (Low Power)
An EMS signal will be sent to receiver automatically to turn off
receiver. To avoid the interruption during operation, check
battery power frequently.