Data Critical Corporation AVTS1010 ユーザーズマニュアル
AlarmView™ System User’s Guide
{insert part #} Page 17
Section 3: Installation
Setting Up Transmitter
Before first use of a transmitter or transmitters in a care unit, perform a
Transmitter Range Test (Per Section 5: Testing & Periodic Maintenance,
“Transmitter Range Test: Survey Paging”). This will establish limits of
unit coverage.
Connect Antenna
1. Connect antenna to antenna connector on top of transmitter.
For best transmission, antenna must be pointing up.
{Insert antenna connector
Figure 5)}
Antenna Connector
!
!
!
Range will be limited if antenna is not vertical.
Connect to AC Power
1. Connect power supply cord to power input port on rear panel
of transmitter.
{Insert power input port
(Figure 6)}
Power Input Port
2. Plug AC power cord into the other end of power supply. Use
only hospital-grade power cord provided by Data Critical.
3. Plug AC power cord into a properly grounded AC outlet.