Westell Inc. CSI-DSP25XCP ユーザーズマニュアル
- 8 -
Functional Overview
CSI digital repeaters incorporates the following features for convenient operation, access,
protection, and control.
protection, and control.
•
Network Configuration and Control using either a webpage style GUI through
any standard browser or a menu driven user interface using the serial port.
Note: GUI does not require Internet access.
•
User Gain Control (affects all passbands)
•
Automatic Gain Control
•
Automatic Power Control
•
Oscillation Protection
•
Over Drive Protection (P.A. limiting)
•
Under/Over Voltage Protection
•
Fault Protection
•
Alarm Notification - Local/Remote
•
Upgrade Support - Local/Remote
•
External Interfaces - USB/Ethernet/Serial
•
Re-loadable filters - Local/Remote
•
Web-based monitoring and control - Local/Remote
•
Persistent Status and Error information
LED Indicator
Automatic safety precautions are built into the amplifier system. In the case of a catastrophic system
event, a shutdown circuit is incorporated that will disable all emissions should the uplink input or downlink
input be over driven or should an oscillation or output overpower event occur. The amplifier will periodi-
cally attempt to recover from the detected condition automatically. Warning light indicators are as follows:
event, a shutdown circuit is incorporated that will disable all emissions should the uplink input or downlink
input be over driven or should an oscillation or output overpower event occur. The amplifier will periodi-
cally attempt to recover from the detected condition automatically. Warning light indicators are as follows:
*
Note: During Power up, the repeater will require a approximately three minutes for
the internal computer to boot up. During this time the LED on the front panel may light
and go out several times.
and go out several times.
Do not unplug the unit while it is in the boot up process!
When a boot up is complete and no alarm conditions exist, the LED indicator will be illuminated green.
Should a fault condition develop the LED will illuminate red and the user may check the status page
of the GUI for the nature of the fault.
Should a fault condition develop the LED will illuminate red and the user may check the status page
of the GUI for the nature of the fault.
*